Remove ads

November 3, 2016 by
Gas Turbine Engine Quiz
EASA : Module15 Gas Turbine Engine Question
DGCA AME EXAM JET ENGINE QUESTIONS
1. The highest turbine bearing temperature takes place
2. On an EGT thermocouple system, the hot junction
3. Increasing ram effect with increased speed
4. On an rpm system using a synchronous generator, the pointer is deflected by
5. Fuel system inhibiting oil is
6. Shrouded blades allow
7. NGV's form
8. The working fluid of constant speed drive (CSD) is
9. After placing an engine in a MVP envelope
10. When an installed engine is not to be used for a period of up to 7 days
11. With a decrease in fuel SG, what is the result on uncompensated governor?
12. Installed engines must be re-preserved after preservation at least every
13. When the engine is not running. The EPR gauge shows 1.0 then
14. When using water methanol in an axial flow compressor, it is injected in
15. The compensation device on an EGT system must be re-calibrated after
16. Normal fuel/air ratio for successful combustion is
17. Engine anti-ice is taken from the
18. A fixed throttle with increased mass airflow
19. On a FADEC engine the EEC
20. Compression occurs

Share This

Remove ads